©American DJ Supply® - www.americandj.com - Fusion FX Bar 5 Instruction Manual Page 12©American DJ Supply® - www.americandj.com - Fusion FX Bar 5 Instruction Manual Page 11
Fusion FX Bar 5 System Menu
xtures will now have contrast movement to each other.
SHND: SH 0 - SH 16 - Show modes 0 - 16 (Factory programs)
Show mode can run with or without sound active mode on. With
sound active mode on, the shows will tend to run faster.
1. Press the MENU button until “SHND” is displayed, press
ENTER.
2. “SH X” will now be displayed, “X” representing a number
between 0-16. Shows 1-16 are preset shows, while “SH 0”
is random show. Press the UP or DOWN buttons to nd your
desired show.
3. Press ENTER, and then press and hold the MENU button for at
least 3 seconds to conrm.
SOUN - In this mode you can run in sound active mode.
1. Press the MENU button until “SOUN” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
conrm.
SENS - Sound sensitivity control.
1. Press the MENU button until “SENS” is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sensi-
tive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button for at
least 3 seconds to conrm.
Fusion FX Bar 5 System Menu
ADDr - DMX Address Setting via control board -
1. Press the MENU button until “ADDr” is displayed, press
ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to nd your desired address.
3. Press ENTER to conrm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least
3 seconds.
SLND - This will let you set unit as a slave in a master/
slave conguration.
1. Press the MENU button until “SLND” is displayed, press
ENTER. Either “SL 1” or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to conm.
NOTE: In a Master/Slave conguration you can make one
xture the Master and then set the next xture to “SL 2”, the
On-Board System Menu.
The Fusion FX Bar 5 comes with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the MENU button. Tap the UP or
DOWN buttons until you reach function you wish to change. When you
reach the function you wish to change press the ENTER button. When
a function is selected use the UP or DOWN buttons to change the func-
tion settings. Once your changes are made press the ENTER button,
and then press and hold the MENU button for at least three seconds
to conrm and lock the change into the system memory. If the MENU
button is not pressed and held within eight seconds the xture will
automatically conrm and lock the change into the system memory. To
exit without making any changes press the MENU button.
Comments to this Manuals