American DJ DCD-PRO400 User Manual download pdf (Page 16)

DMXDart Operation

5 – Parameters

1 – Type Setup: This selection allows you to configure the characteristics

of the DMX output signal. Sets the “flavor” of the DMX signal: A, B, C, or

U. A through C are factory defaults, and U is a user programmable type

for “tweaking” the DMX output. This can be especially useful in

determining why a device that is considered to be DMX does not respond

to a particular console

(More required… DAVE ??)

2 – Sync Setup: Turns on the Scope Sync port, and sets up the portion of

the signal to sync to. (See Rx Sync Test for further information)

3 – Data Loss Test: Intentionally transmits poor DMX signal, manipulated

by the user. Inserts 100ms to 2 s of “dead time” into the signal at a

specified point. Tests DMX reception equipment for its reaction to poor

data.

Printing DMX Data

Note:

Printing requires the optional Hewlett Packard 82240B Thermal Infrared printer.

From the Transmit DMX512 submenu, press 5 – Print DMX Data to enter the

print screen.

Transmit DMX512Transmit DMX512

Print DataPrint Data

* Hexval CH:001-050* Hexval CH:001-050

From this display, all of the print options are set. For example, to print the

decimal value of channels 1 to 400 press Ü to move the cursor (^) to below the

format setting (currently Hexval):

Transmit DMX512Transmit DMX512

Print Mode SelectPrint Mode Select

* Hexval CH:001-050* Hexval CH:001-050

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

No comments

American DJ DCD-PRO400 User Manual Page 16